FL-700
TAIL LIGHT ALTERNATING FLASHERS.
click on image to enlarge
DIAGRAM
- SPECIFICATIONS
- INSTALLATION
| Power | 12 volts, negative ground system |
| Flash rate | Nominal 1.9 per second on wigwag pattern |
| Current output | 15 amps 180 watts |
| Flash Pattern | Alternating Tail Lights with backup lights |
| Three Wire Systems | Brake lights and turn signal. Use the same light bulb |
| Four Wire Systems | Brake lights and turn signal. Use separate light bulbs |
Flashing will automatically stop "disable" and allow normal operation if brake pedal is depressed (brake lights on) or when shifting into reverse
Mounting
Power and Ground
Three Wire System
Mount in the vehicle's trunk near the brake lights.
Power and Ground
Connect the BLACK wire to a reliable chassis negative connection point
Connect the RED wire through 20 amp fuse to positive 12 volts. Use 16 gauge wire
Connect the WHITE wire through a switch (very low current requirement).
Three Wire System
(Turn signal and brake light use same bulb)
- Locate and cut the wire that feeds power to the left turn signal and brake light.
- Connect the PURPLE wire to the lead that goes back to the signal brake light.
- Connect the YELLOW wire to the remaining lead wire from the front of the vehicle.
- Locate and cut the wire that feeds power to the right turn signal and brake light.
- Connect the BROWN wire to the lead that goes back to the right turn signal brake light.
- Connect the GREY wire to the remaining lead wire from the front of the vehicle.
- Locate and cut the wire that feeds power to the back-up lights.
- Connect the ORANGE wire to the lead that goes back to the back-up lights.
- Connect the BLUE wire to the remaining lead wire from the front of the vehicle.
(Turn signal and brake light use separate lamps)
- Locate and cut the wire that feeds power to the left brake light.
- Connect the PURPLE wire to the lead that goes back to the brake light.
- Connect the YELLOW wire to the remaining lead wire from the front of the vehicle.
- Locate and cut the wire that feeds power to the right brake light.
- Connect the BROWN wire to the lead that goes back to the right brake light.
- Connect the GREY wire to the remaining lead wire from the front of the vehicle.
- Locate and cut the wire that feeds power to the back-up lights.
- Connect the ORANGE wire to the lead that goes back to the back -up lights.
- Connect the BLUE wire to the remaining lead wire from the front of the vehicle.
