SPECIFICATIONS

Power	12 volts, negative ground system
Flash rate	Nominal 1.9 per second on wigwag pattern
Current output	15 amps 180 watts
Flash Pattern	Alternating Tail Lights with backup lights
Three Wire Systems	Brake lights and turn signal. Use the same light bulb
Four Wire Systems	Brake lights and turn signal. Use separate light bulbs

Flashing will automatically stop "disable" and allow normal operation if brake pedal is depressed (brake lights on) or when shifting into reverse

INSTALLATION

Mounting
Mount in the vehicle’s trunk near the brake lights.

Power and Ground
Connect the BLACK wire to a reliable chassis negative connection point
Connect the RED wire through 20 amp fuse to positive 12 volts. Use 16 gauge wire
Connect the WHITE wire through a switch (very low current requirement).

Three Wire System
(Turn signal and brake light use same bulb) 1. Locate and cut the wire that feeds power to the left turn signal and brake light.
2. Connect the PURPLE wire to the lead that goes back to the signal brake light.
3. Connect the YELLOW wire to the remaining lead wire from the front of the vehicle.
4. Locate and cut the wire that feeds power to the right turn signal and brake light.
5. Connect the BROWN wire to the lead that goes back to the right turn signal brake light.
6. Connect the GREY wire to the remaining lead wire from the front of the vehicle.
7. Locate and cut the wire that feeds power to the back-up lights.
8. Connect the ORANGE wire to the lead that goes back to the back-up lights.
9. Connect the BLUE wire to the remaining lead wire from the front of the vehicle

Four Wire System
(Turn signal and brake light use separate lamps)
1. Locate and cut the wire that feeds power to the left brake light.
2. Connect the PURPLE wire to the lead that goes back to the brake light.
3. Connect the YELLOW wire to the remaining lead wire from the front of the vehicle.
4. Locate and cut the wire that feeds power to the right brake light.
5. Connect the BROWN wire to the lead that goes back to the right brake light.
6. Connect the GREY wire to the remaining lead wire from the front of the vehicle.
7. Locate and cut the wire that feeds power to the back-up lights.
8. Connect the ORANGE wire to the lead that goes back to the back -up lights.
9. Connect the BLUE wire to the remaining lead wire from the front of the vehicle.

Caution: Wires to the turn signals are not modified. Do not connect or disturb the wiring to the third stop lamp.